Burrum Heads is in Fraser Coast LGA, QLD, postcode 4659, with population 2,538.
The page is still useful for local context, but the evidence stack is too thin for a clean one-page call. Use nearby stronger suburbs or compare mode before treating it as a serious shortlist decision.
Population movement supports a growth-led read.
Evidence depth is verify-heavy, so the profile should be treated as provisional. The page is thin enough that nearby alternatives should be checked before shortlisting.
Price series isn't recorded for this suburb. Census housing data is shown instead.
83% of homes here are owner-occupied and 15% rented, with 4% of landlords negatively geared.
83% owner-occupied — owner-occupiers hold longer and absorb rate shocks, supporting price stability.
ABS Census 2021 tenure (G37), ATO postcode rental statistics, and QuickProperty's investor-exposure index. Owner-occupied = owned outright + with a mortgage.
This suburb 37% · QLD median 19%
Nationally · lighter rent burden than 2% of AU suburbs
Owners with a mortgage repay a median of $1,348/mo, while renters pay about $1,322/mo — owning runs $26/mo higher on these medians.
At the median asking rent, about 60% of households here would spend more than 30% of income on rent (rent stress line: $1,017/wk income).
Getting to work: 77% drive, 1% public transport, 3% walk or cycle, 13% worked from home (2021 Census, taken during COVID-era work-from-home arrangements).
Top 93% most liveable of 4,565Australian suburbs.
Bar = this suburb's percentile · tick = typical (median) peer
Suburb-level access-density index (not an address-level walk-time score), normalised within Australian suburbs. Method based on the Urban Liveability Index (Higgs et al. 2019) and Walk Score — three equal-weighted domains combined with an imbalance penalty.
Development screen
The official state policy page could not be reliably re-verified automatically in the latest review. Treat this screen as preliminary and confirm the current planning and building requirements with the state source and local council.
Rental use: State rental-law changes allow secondary dwellings to be rented more broadly, but implementation depends on an approved lawful dwelling and local planning/building requirements.
Open official policy sourceSuburb share of occupied private dwellings recorded as separate houses.
Near the state median
State median 79.3% · 838 valid suburbs
A comparable planning-zone layer is not staged for this state.
Demand context only; it does not establish permission to rent a secondary dwelling.
15.2 pp below the state median
State median 29.7% · 838 valid suburbs
The staged suburb layer shows no mapped exposure; this is not a property-level clearance. No broad-area layer staged for this suburb.
Approval pathway
This is an investigation sequence, not a guarantee that every step applies or that approval will be granted.
The current secondary dwelling / granny flat position needs direct confirmation before relying on this screen.
Confirm zoning, lot controls, overlays, setbacks, site coverage and whether planning approval is required.
Confirm the building approval route after the design, site classifications, services and construction requirements are known.
Confirm long-term rental, short-stay or family-use rules separately from permission to construct the dwelling.
Property due diligence
Every check starts unconfirmed. Progress stays in this browser and suburb evidence never clears an address-level requirement.
Confirm title dimensions, usable site area and any minimum lot threshold.
Metadata only. QuickProperty does not store or upload the underlying document.
Test setbacks, private open space, landscaping and maximum site coverage against a concept plan.
Metadata only. QuickProperty does not store or upload the underlying document.
Check survey levels, soil classification, retaining needs and likely earthworks.
Metadata only. QuickProperty does not store or upload the underlying document.
Obtain current property-level zoning, overlays and applicable planning controls.
Metadata only. QuickProperty does not store or upload the underlying document.
Review the title for easements, covenants, restrictions and common property.
Metadata only. QuickProperty does not store or upload the underlying document.
Locate assets and connection points, then confirm capacity, clearances and discharge requirements.
Metadata only. QuickProperty does not store or upload the underlying document.
Confirm service routes, upgrade needs and whether separate metering is permitted or practical.
Metadata only. QuickProperty does not store or upload the underlying document.
Test driveway width, gradients, turning, parking and emergency access requirements.
Metadata only. QuickProperty does not store or upload the underlying document.
Order an address-level bushfire assessment and determine any BAL construction response.
Metadata only. QuickProperty does not store or upload the underlying document.
Obtain property flood information and check floor levels, flow paths and drainage constraints.
Metadata only. QuickProperty does not store or upload the underlying document.
Confirm site classifications that affect structural design, materials and durability.
Metadata only. QuickProperty does not store or upload the underlying document.
Confirm exemption, complying pathway or permit requirements with the responsible authority.
Metadata only. QuickProperty does not store or upload the underlying document.
Identify required survey, design, engineering, energy, certification and inspection evidence.
Metadata only. QuickProperty does not store or upload the underlying document.
Confirm occupation, rental, short-stay and family-use rules plus insurance and tax implications.
Metadata only. QuickProperty does not store or upload the underlying document.
Building due diligence
The National Construction Code is the baseline. Local hazards and site classifications can change the required structure, materials, fixings, insulation and detailing.
About 0.0% of the suburb intersects mapped bushfire-prone land.
May affect: External construction · Roof and wall systems · Openings, screens and decks
Confirm the NCC climate zone used for the building design and energy provisions.
May affect: Insulation and glazing · Condensation control · Roof-space ventilation
A suburb layer cannot determine the site wind classification or Bushfire Attack Level.
May affect: Structure and tie-downs · Cladding and fixings · Openings and bushfire detailing
Confirm marine or corrosive exposure and the applicable termite-management requirements.
May affect: Fasteners and connectors · Roofing and coatings · Termite management
This screen identifies investigation triggers, not building quality or property compliance. Confirm the address, design and current jurisdiction rules with the council, building surveyor or certifier, designer and engineer.
NCC 2022 Housing Provisions: how to use · NCC 2022 Volume Two and Housing Provisions
Estimated exposure to NSW RFS Bush Fire Prone Land (CC BY), point-sampled across the suburb. This shows how much of the suburb sits within the official hazard layer — it is not a Bushfire Attack Level (BAL) rating or a property-level assessment. Obtain a BAL assessment (AS 3959) for an individual property.
ABS population projection (2022 base) for the Burrum - Fraser SA2 statistical area — the finest official projection grain available; suburb-level projections do not exist.
Located in Queensland within the Fraser Coast local government area, Burrum Heads is a compact suburb (postcode 4659). It is home to about 2,538 residents, with an older demographic and a median age of 64. Households earn a median income of $42K per year, with an average household size of 2 people. Recent annual estimates show population movement into the broader catchment, with population growth running at +2.1% year-on-year at the LGA level. QLD employment has moved +1.5% year-on-year in the official ABS Labour Force trend series, which provides the broader jobs backdrop for this suburb. QLD also had 35 Commonwealth-backed major projects under construction, 16 underway, and 30 in planning as at 2025-09-01, which is useful as a broader delivery backdrop rather than a suburb-specific project count. The most common occupations are professionals, community & personal service, clerical & administrative. Employment in the area leans toward healthcare and construction. The top ancestries reported are English, Australian, Irish.
The median weekly rent is $305 (Census 2021). The median monthly mortgage repayment is $1,348.
The crime rate in the Fraser Coast LGA is moderate at 5,526 incidents per 100,000 population.
On the investment side, Population growth of +2.1% year-on-year points to strong growth demand fundamentals. Building approvals have changed +0% year-on-year, indicating steady development activity.
Save suburbs here while you browse. Once the shortlist has two or more names, hand it straight into compare.
No saved AU suburbs yet.
No saved suburbs yet. Start with one ranking or suburb page, then compare once you have two candidates.
Open rankings to save the first candidates.
Much of Burrum Heads rests on evidence that should be verified before a decision.
QuickProperty mixes release files, Census baselines, and matched local services on this page. Read the status panel before treating every metric as equally fresh.
QVAS residential dwelling sales aggregated to SA2 and mapped to suburb pages
This gives you directional coverage, but it is weaker than a current rent release.
Schools, transport, and hospitals are useful as presence signals, but they still have different source cadences.
This page stays indexable because Burrum Heads is a real locality with enough context to be directionally useful. The tradeoff is that coverage is lighter than a stronger suburb profile, so the read should stay cautious.
Read it as a starting locality brief, then cross-check the suburb story against better-covered nearby markets or the state hub.
The main gaps on this page are school matches, hospital coverage, and transport stops. That narrows how much confidence you should place on a single-page read.
Start here for context, then open compare, the state hub, or larger nearby suburbs before treating this as a complete market decision.
This page remains visible, but it should be read as a locality brief rather than a full-confidence suburb profile.
This page is useful for direction-setting, not closure. Use it to frame the locality, then confirm the story with compare, stronger nearby suburbs, and the state hub.
If Burrum Heads feels too thin on its own, use these nearby suburbs as stronger local reads before making a shortlist decision.
pop same · adds house price coverage · rent -$66/wk
Better covered alternative: use this as the stronger reference point before judging the thin page.
pop -300 · adds house price coverage · rent +$78/wk
Better covered alternative: use this as the stronger reference point before judging the thin page.
Burrum Heads is in the Fraser Coast Local Government Area, QLD, postcode 4659. Council-level context for Fraser Coast LGA (suburb mix, population, rent, and price coverage) is available on the QuickProperty LGA page.
The median weekly rent in Burrum Heads is $305/wk, based on ABS Census 2021 rent fallback.
QuickProperty's investment signals for Burrum Heads show: Strong Growth, Steady. These are computed from price, rent, income, and population data — not an opaque score.
Property prices come from state Valuers General offices and ABS Data by Region. Demographics are from ABS Census 2021. School ICSEA scores are from ACARA. Crime statistics are from state police agencies. Transport data is sourced from GTFS feeds.
Property prices update quarterly. RBA macro indicators update with each deploy. Demographics are from Census 2021. School ICSEA scores are from ACARA 2025.