Elderslie is in Camden LGA, NSW, postcode 2570, with population 7,878.
The page has enough signal to be useful, but the story is mixed rather than decisive. Use compare mode to pressure-test it against stronger nearby options, then use the calculator if it still makes the shortlist.
Population movement supports a growth-led read.
Price series isn't recorded for this suburb. Census housing data is shown instead.
Indicative cashflow is interest-only and excludes tax — use the calculator for a full projection. Turnover divides recorded sales by an estimated household count (population over average household size).
This suburb 35% · NSW median 21%
Nationally · lighter rent burden than 2% of AU suburbs
Owners with a mortgage repay a median of $2,383/mo, while renters pay about $3,250/mo — renting runs $867/mo higher on these medians.
At the median asking rent, about 44% of households here would spend more than 30% of income on rent (rent stress line: $2,500/wk income).
1 of 2 schools here operate published enrolment zones (catchments). Zone boundaries set eligibility — check the official source for the exact catchment. Not enrolment advice.
Top 61% most liveable of 4,565Australian suburbs.
Bar = this suburb's percentile · tick = typical (median) peer
Suburb-level access-density index (not an address-level walk-time score), normalised within Australian suburbs. Method based on the Urban Liveability Index (Higgs et al. 2019) and Walk Score — three equal-weighted domains combined with an imbalance penalty.
Development screen
Permitted in residential zones under the Housing SEPP; may be approved by consent or as complying development when Housing SEPP and Codes SEPP standards are met.
Rental use: Secondary dwelling rental use is allowed as a dwelling use, subject to planning and tenancy rules.
Open official policy sourceHousing-structure evidence is not staged.
A comparable planning-zone layer is not staged for this state.
Rental-demand context is not staged.
No broad-area layer staged for this suburb. No broad-area layer staged for this suburb.
Approval pathway
This is an investigation sequence, not a guarantee that every step applies or that approval will be granted.
QuickProperty reviewed the official secondary dwelling / granny flat policy source.
Test consent or complying-development eligibility, including the 450 m² lot marker and all other standards.
Confirm the building approval route after the design, site classifications, services and construction requirements are known.
Confirm long-term rental, short-stay or family-use rules separately from permission to construct the dwelling.
Property due diligence
Every check starts unconfirmed. Progress stays in this browser and suburb evidence never clears an address-level requirement.
Confirm title dimensions, usable site area and any minimum lot threshold.
Metadata only. QuickProperty does not store or upload the underlying document.
Test setbacks, private open space, landscaping and maximum site coverage against a concept plan.
Metadata only. QuickProperty does not store or upload the underlying document.
Check survey levels, soil classification, retaining needs and likely earthworks.
Metadata only. QuickProperty does not store or upload the underlying document.
Obtain current property-level zoning, overlays and applicable planning controls.
Metadata only. QuickProperty does not store or upload the underlying document.
Review the title for easements, covenants, restrictions and common property.
Metadata only. QuickProperty does not store or upload the underlying document.
Locate assets and connection points, then confirm capacity, clearances and discharge requirements.
Metadata only. QuickProperty does not store or upload the underlying document.
Confirm service routes, upgrade needs and whether separate metering is permitted or practical.
Metadata only. QuickProperty does not store or upload the underlying document.
Test driveway width, gradients, turning, parking and emergency access requirements.
Metadata only. QuickProperty does not store or upload the underlying document.
Order an address-level bushfire assessment and determine any BAL construction response.
Metadata only. QuickProperty does not store or upload the underlying document.
Obtain property flood information and check floor levels, flow paths and drainage constraints.
Metadata only. QuickProperty does not store or upload the underlying document.
Confirm site classifications that affect structural design, materials and durability.
Metadata only. QuickProperty does not store or upload the underlying document.
Confirm exemption, complying pathway or permit requirements with the responsible authority.
Metadata only. QuickProperty does not store or upload the underlying document.
Identify required survey, design, engineering, energy, certification and inspection evidence.
Metadata only. QuickProperty does not store or upload the underlying document.
Confirm occupation, rental, short-stay and family-use rules plus insurance and tax implications.
Metadata only. QuickProperty does not store or upload the underlying document.
Building due diligence
The National Construction Code is the baseline. Local hazards and site classifications can change the required structure, materials, fixings, insulation and detailing.
No local compliance layer is staged.
This is missing evidence, not evidence that the property has no constraints.
Confirm the NCC climate zone used for the building design and energy provisions.
May affect: Insulation and glazing · Condensation control · Roof-space ventilation
A suburb layer cannot determine the site wind classification or Bushfire Attack Level.
May affect: Structure and tie-downs · Cladding and fixings · Openings and bushfire detailing
Confirm marine or corrosive exposure and the applicable termite-management requirements.
May affect: Fasteners and connectors · Roofing and coatings · Termite management
This screen identifies investigation triggers, not building quality or property compliance. Confirm the address, design and current jurisdiction rules with the council, building surveyor or certifier, designer and engineer.
NCC 2022 Housing Provisions: how to use · NCC 2022 Volume Two and Housing Provisions
Elderslie is a mid-sized suburb in New South Wales within the Camden local government area (postcode 2570). The area has roughly 7,878 residents and a mix of families and early-career residents, with a median age of 34. Households earn a median income of $112K per year, with an average household size of 2.8 people. Recent annual estimates show population movement into the broader catchment, with population growth running at +3.7% year-on-year at the LGA level. NSW employment has moved +1.2% year-on-year in the official ABS Labour Force trend series, which provides the broader jobs backdrop for this suburb. NSW also had 35 Commonwealth-backed major projects under construction, 17 underway, and 67 in planning as at 2025-09-01, which is useful as a broader delivery backdrop rather than a suburb-specific project count. The most common occupations are managers, machinery operators & drivers, clerical & administrative. Employment in the area leans toward mining and healthcare. The top ancestries reported are Australian, English, Irish.
The current median weekly rent is $750. The median monthly mortgage repayment is $2,383.
Elderslie is served by 2 schools, including 1 primary, 1 secondary. The average ICSEA score is 1000, which is around the national average of 1,000. The crime rate in the Camden LGA is low at 1,698 incidents per 100,000 population.
On the investment side, Population growth of +3.7% year-on-year points to strong growth demand fundamentals. Building approvals have changed +0% year-on-year, indicating steady development activity.
Save suburbs here while you browse. Once the shortlist has two or more names, hand it straight into compare.
No saved AU suburbs yet.
No saved suburbs yet. Start with one ranking or suburb page, then compare once you have two candidates.
Open rankings to save the first candidates.
Elderslie carries enough direct local evidence for a first-pass decision.
QuickProperty mixes release files, Census baselines, and matched local services on this page. Read the status panel before treating every metric as equally fresh.
Official sale records parsed from cached Bulk PSI ZIP files with parser guardrails for token sales, non-house zoning, and low-value strata component records
Use current rent as a starting signal, not as a fixed underwriting truth.
Schools, transport, and hospitals are useful as presence signals, but they still have different source cadences.
Elderslie is in the Camden Local Government Area, NSW, postcode 2570. Council-level context for Camden LGA (suburb mix, population, rent, and price coverage) is available on the QuickProperty LGA page.
The median weekly rent in Elderslie is $750/wk, based on the current market rent dataset. The current rent signal is rent-pressure candidate.
Rent-pressure candidate: Elderslie rents screen above the local benchmark. Use this as a suburb screening signal before comparing candidates or modelling a purchase; the matching rent ranking can provide broader market context.
QuickProperty's investment signals for Elderslie show: Strong Growth, Steady. These are computed from price, rent, income, and population data — not an opaque score.
Property prices come from state Valuers General offices and ABS Data by Region. Demographics are from ABS Census 2021. School ICSEA scores are from ACARA. Crime statistics are from state police agencies. Transport data is sourced from GTFS feeds.
Property prices update quarterly. RBA macro indicators update with each deploy. Demographics are from Census 2021. School ICSEA scores are from ACARA 2025.